Provides background information, apparatus needed, and procedures for an experiment to measure transient response of a stirred vessel. The inexpensive apparatus can be used for two different experiments, reducing cost per experiment. Both experiments use salt dilution as the method of demonstration. (Author/JN)

Ethylene hydrogenation on a platinum catalyst, electrolytically applied to a tube wall, is a good system for the study of the interactions between diffusion and surface reaction in heterogeneous catalysis. Theoretical background, apparatus, procedure, and student performance of this experiment are discussed. (BB)

This paper describes an experiment designed to reveal the consequences of the development of a concentration boundary layer. The rate of a mass transfer limited electrochemical reaction is measured and used to obtain the dependence of average Sherwood number on Reynolds number and entrance length. (Author/BB)

Described is an experiment which uses an autotrophic bacterium to anaerobically oxidize hydrogen sulfide to sulfate in a batch-stirred tank reactor. Discusses background information, experimental procedure, and sample results of this activity. (CW)

Principles, experimental procedures, results, and discussion of this method are included here. The method was used in undergraduate laboratory courses in Toulouse, France. (BB)

For this 12-hour laboratory project students examine a model and explain why equipment is placed where it is, and then install some piping on the model. (BB)

Describes laboratory experiments of a chemistry course on advanced process control. The equipment for the process around which these experiments were developed by the University of Louisville was constructed from data provided by Exxon Oil Company. (HM)

Describes the process dynamics and control program developed by the chemical engineering department at the University of California, Santa Barbara. Undergraduate and graduate control courses and real-time computing courses are included. (HM)

Describes a simple thermodynamics experiment recommended for use in beginning chemical engineering laboratory courses. Outlines the theory behind the experiment, which determines the specific heat of a liquid. Discusses the construction, operation, and maintenance of the apparatus involved, along with the experimental procedure. (TW)

Follows the increase of the pH in a solution of vinegar during neutralization with commercial antacid tablets. Provided are background information, equipment details, procedures, and details of the data analysis. (MVL)

Focuses on the development of a pilot unit for use in an advanced separations process laboratory in an effort to develop experiments on such processes as reverse osmosis, ultrafiltration, adsorption, and chromatography. Discusses reverse osmosis principles, the experimental system design, and some experimental studies. (TW)

Describes an experiment developed and used in the unit operations laboratory course at the University of Wyoming. Involves the liquid-phase adsorption of an organic compound from aqueous solution on activated carbon, and is relevant to adsorption processes in general. (TW)

Describes a laboratory experiment for freeze-drying fruits and vegetables which aims to expose college students to the principles of drying and simultaneous heat and mass transfer. The experimental apparatus, procedure of the experiment, and data analysis are also included. (HM)

Described is a reliable and predictable laboratory experiment which represents the result of an integrated approach to design with an emphasis on teaching. Notes the flat-celled rig has logged over 100 hours service in 2 years without any problems. (MVL)

Discussed are problems encountered when a gas absorption experiment with strong measurement error is used. Notes students either avoid the experiment or report it as defective. Provides ideas to make lab experiments more instructive. (MVL)