Video motion analysis allows tracing trajectories of objects in motion and is an established method in physics education. Tablet computers, with their integrated cameras, offer the opportunity to both record and analyze dynamic motions during experiments on a single device. This enables students to work without transitioning the data between…

A wood cantilever of length ~2.5 m is driven into resonance using the hand as a simple driver. Video recordings of these oscillations are analyzed to determine experimental second harmonic (n = 2) damped resonance frequencies. These frequencies are compared to theoretical ones, obtained from measurements of elastic moduli, damping properties, and…

A novel technology that employs computer vision (CV) to carry out an automatic titration experiment is presented. The experiment is designed to facilitate understanding of the basics of the CV technology and its application in chemistry among undergraduate students. The standard chemical procedure of titration has been chosen, since it is…

The image of free-falling bar has been recorded to study the effect of the motion on its observed length. This moving bar image is analysed using the Tracker software to determine its length and the end bar's position. An elongated appearance of the bar has been observed with movement. This effect relies on the speed and the exposure time during…

This work presents the design of an inexpensive electronic system to measure water temperature and generate an experimental data set used to verify the fitting between experimental and theoretical curves of a water-cooling process. The cooling constant is computed with three different theoretical methods to check their efficiency and this approach…

Air pollution is one of our day's significant reasons for human health problems and affects every community throughout the world. Monitoring air pollution is a key aspect of raising awareness and pollution mitigation approaches followed by different nations. This paper targets to develop a low-cost Internet of things-based embedded system to…

Here, we present a 3D printed experimental apparatus that students can use to acquire interference and diffraction quantitative data from light passing through a single or double-slit experiment. We built a linear screw stage with a multiturn potentiometer connected to its leadscrew as a position sensor. Using an Arduino, we collected light…

We describe a simple STEM project for students to learn to measure atmospheric pressure by using a sensor of the type BMP180 together with the Arduino electronic platform. The collected experimental data, together with simple experiments, can be used to study the different pressure units and the relationship between pressure and force. Also, they…

The real-time graphing of simple harmonic motion of mass on springs with an Arduino based on an experiment set for teaching and learning physics in high schools where students can learn from real experiences. The objectives of this study are to create and develop a real-time measurement for vertical oscillations of mass on springs using the…

Powerbanks differ in the amount of energy they can store. Usually this capacity (in a colloquial sense) of the powerbanks is stated in the form of charge in mAh for effective advertising. From a physical point of view, shouldn't the energy that a powerbank can provide be of interest? For students, charging smartphones with power banks is…

Recognized as one of the most beautiful experiments of all time, the oil drop experiment performed by Robert Millikan and his graduate students (primarily Harvey Fletcher) is a standard in the repertoire of experiments performed by undergraduate physics students. However, "as a teaching lab it does not enjoy a good reputation for three…

At constant current (I) the forward bias potential (V) of a "pn" junction diode may be considered to vary linearly with temperature (t) within a temperature range. Based on this property we have constructed diode thermometer using germanium (Ge) and silicon (Si) diodes. The experimental "V-t" data at constant forward current…

This paper describes a number of active learning strategies based on implementing the Raspberry Pi as low-cost single-board computing device for carrying out physics laboratory activities. This Microcomputer-Based Laboratory (MBL) Project has been funded by the Baden-Württemberg Foundation and it encompasses the use of high-accuracy yet…

There is a relatively simple way of using radioactive material in classroom experiments: uranium glass, which provides teachers with a suitable substance. By using the right computer software and a radiation sensor, it can be demonstrated that uranium glass emits radiation at a greater rate than the background radiation and with the aid of UV…

First order processes are of paramount importance for chemical kinetics. In a well-established demonstration experiment, the flow of water out of a vertical glass tube through a capillary simulates a chemical first order process. Here, a digital version of this experiment for lecture hall demonstrations is presented. To this end, water flowing out…