During the last decade the development of modern digital media such as smartphones and tablet computers has enabled new experimental possibilities in STEM education. Besides these now nearly ubiquitous devices, the fields of virtual reality (VR) and augmented reality (AR) also made huge progress and reached education. In this paper we introduce an…

A remote-controlled experiment for power electronics was developed for a virtual laboratory. Power converter experiments were set up, allowing students to conduct a remote-controlled experiment with special hardware and electric power. Students can activate parameter controls, connect wires, and tune electric load conditions with preset electronic…

This paper proposes a novel e-learning system for technical experiments involving the construction of practical electronic circuits; this system would meet the various demands of individual experimenters. This mixed mode is beneficial for practical use in that an experimenter who does not have sufficient circuit components for circuit making can…

This paper presents the basic features of a software system developed to support the teaching of digital logic, as well as the experience of using it in the Digital Logic course taught at the School of Electrical Engineering, University of Belgrade, Serbia. The system has been used for several years, both by students for self-learning and…

Servomotors are widely used in computerized numerically controlled (CNC) machines, hence motion control is a major topic covered in undergraduate/graduate engineering courses. Despite the fact that several syllabi include the motion dynamics topic in their courses, there are neither suitable tools available for designing and simulating multi-axis…

As one important professional base course in the electric information specialty, the course of "high frequency electronic circuit" has strong theoretical characteristic and abstract content. To enhance the teaching quality of this course, the computer simulation technology based on Multisim is introduced into the teaching of "high…

Switched-mode power supplies (SMPS) are becoming an essential part of many electronic systems as the industry drives toward miniaturization and energy efficiency. However, practical SMPS design courses are seldom offered. In this paper, a generalized MATLAB/SIMULINK modeling technique is first presented. A proposed practical SMPS design course at…

This paper suggests a pedagogical approach to teaching the subject of behavioral modeling of switch-mode power electronics systems through simulation by general-purpose electronic circuit simulators. The methodology is oriented toward electrical engineering (EE) students at the undergraduate level, enrolled in courses such as "Power…

This paper presents a low-cost hands-on experiment for a classical undergraduate controls course for non-electrical engineering majors. The setup consists of a small dc electrical motor attached to one of the ends of a light rod. The motor drives a 2-in propeller and allows the rod to swing. Angular position is measured by a potentiometer attached…

This paper describes the goals, pedagogical system, and educational outcomes of a three-semester curriculum in microelectromechanical systems (MEMS). The sequence takes engineering students with no formal MEMS training and gives them the skills to participate in cutting-edge MEMS research and development. The evolution of the curriculum from…

While learning a complex skill in science using a computer-based simulation, optimal timing of information presentation facilitates learning and enhances test performance. An optimal information presentation format is proposed: supportive information is presented before practising a skill, and procedural information is presented during practice.…

Gives an example of the use of a simplified logic simulator in a logic design course. Discusses some problems in logic design classes, commercially available software, and software problems. Describes computer-aided engineering (CAE) software. Lists 14 experiments in the simulated laboratory and presents students' evaluation of the course. (YP)

Present engineering has to deal with increasingly complex systems. In particular, this is the case in electrical engineering. Though this is obvious in microelectronics, also in the field of power systems engineers have to design, operate and maintain highly complex systems such as power grids, energy converters and electrical drives. This is…

Discusses a computer simulation to teach logic design using a Macintosh computer which allows circuits to be built piece by piece. Describes features of the simulation and presents several schematics drawn by the software. (MVL)

Those interested in creating or utilizing computer assisted instruction (CAI) tools for education in electronics have a wide range of multimedia options. Programs are becoming available which offer circuit simulations, mathematical packages for formula processing, instrumentation synthesis and simulation, drafting tools, hypertext construction…