Publication Date
| In 2025 | 0 |
| Since 2024 | 0 |
| Since 2021 (last 5 years) | 0 |
| Since 2016 (last 10 years) | 1 |
| Since 2006 (last 20 years) | 4 |
Descriptor
Source
| IEEE Transactions on Education | 4 |
Author
| Berg, J. M. | 1 |
| Campa, G. | 1 |
| Dahle, Reena | 1 |
| Dallas, T. | 1 |
| Enikov, E. T. | 1 |
| Gale, R. O. | 1 |
| Grundbacher, R. | 1 |
| Hierold, C. | 1 |
| Hoetzel, J. E. | 1 |
| Rasel, Rafiul | 1 |
Publication Type
| Journal Articles | 4 |
| Reports - Descriptive | 3 |
| Reports - Research | 1 |
Education Level
| Higher Education | 4 |
| Postsecondary Education | 3 |
Audience
Location
| Arizona | 1 |
| New York | 1 |
| Switzerland | 1 |
| Texas | 1 |
Laws, Policies, & Programs
Assessments and Surveys
What Works Clearinghouse Rating
Peer reviewed
Direct linkDahle, Reena; Rasel, Rafiul – IEEE Transactions on Education, 2016
This paper presents a series of course modules developed as a high-impact and cost-effective learning tool for modeling and simulating the microfabrication process and design of microelectromechanical systems (MEMS) devices using three-dimensional (3-D) printing. Microfabrication technology is an established fabrication technique for small and…
Descriptors: Educational Technology, Learning Modules, Electromechanical Technology, Printing
Grundbacher, R.; Hoetzel, J. E.; Hierold, C. – IEEE Transactions on Education, 2009
A microelectro-mechanical systems (MEMS) laboratory course (MEMSlab) in the Mechanical and Process Engineering Department at the Swiss Federal Institute of Technology (ETH Zurich), is presented. The course has been taught for four years and has been attended primarily by Master's students from mechanical and electrical engineering; since fall…
Descriptors: Teaching Methods, Foreign Countries, Graduate Study, Engineering Education
Enikov, E. T.; Campa, G. – IEEE Transactions on Education, 2012
This paper presents a low-cost hands-on experiment for a classical undergraduate controls course for non-electrical engineering majors. The setup consists of a small dc electrical motor attached to one of the ends of a light rod. The motor drives a 2-in propeller and allows the rod to swing. Angular position is measured by a potentiometer attached…
Descriptors: Computer Assisted Instruction, Synchronous Communication, Programming, Computer Science Education
Dallas, T.; Berg, J. M.; Gale, R. O. – IEEE Transactions on Education, 2012
This paper describes the goals, pedagogical system, and educational outcomes of a three-semester curriculum in microelectromechanical systems (MEMS). The sequence takes engineering students with no formal MEMS training and gives them the skills to participate in cutting-edge MEMS research and development. The evolution of the curriculum from…
Descriptors: Outcomes of Education, Competition, Curriculum Development, Manufacturing
