This paper describes two examples of teaching situations in which the idea of infinity arises, and supports the conclusion that infinity is not a physical reality but a very powerful and useful mathematical device which facilitates modelling and the solution of problems in physics.

The problem of an electrically charged pendulum above a grounded conducting surface is examined using traditional analyses, such as forces, energy, and torque. The system was numerically modelled using a finite difference method and analysed. A number of classroom activities have been suggested.

This research studied the effectiveness of the simulation-based learning assisted with scaffolding approach to address students' misconceptions (MCs) about projectile motion. The five MCs were related to the direction of the force acting on an object (MC1), the acceleration of an object at the top of the trajectory (MC2), the directions of…

Simulation of physics phenomena is an indispensable part of experimental studies. Undergraduate and postgraduate physics students are often introduced to the simulation of various phenomena as one of the most important pedagogical tools. In this document, we demonstrate the simulations of the two-body decay of a particle and equilibrium states in…

Newton's cradle is often discussed in science classrooms as a clear example of the laws of conservation of momentum and energy although it has been shown that this use is somewhat misleading. Approaches to understanding the behaviour of this apparatus are often over-simplified and deficient or over-complex and with little impact among teachers. In…

The introduction of electric circuit simulation software for undergraduate students in a general physics course is proposed in order to contribute to the constructive learning of electric circuit theory. This work focuses on the lab exercises based on dc, transient and ac analysis in electric circuits found in introductory physics courses, and…

We propose an apparatus that emulates the experiment used by Geiger and Marsden in 1913 to investigate alpha particles (Rutherford) scattering. Using a widely available fused deposition modelling 3D-printer, we built a compartmented and easily assembled educational instrument. The whole apparatus is composed of a 3D-printed chamber and an…

The Cosmic-Ray Extremely Distributed Observatory (CREDO) is the project to search and study ultra high-energy cosmic ray particles from deep space producing simultaneous extensive air showers over the entire exposed surface of the Earth. The concept of the CREDO infrastructure assumes absorbing all kinds of cosmic ray data from any apparatus all…

A glass of water covered with a disk with a hole in it can be turned upside down without spilling the water in the glass, provided the hole is small enough and the disk is pressed against the rim of the glass. A quasistatic numerical simulation based on hydrostatic pressure and surface tension of water was used calculate the critical hole diameter…

In a spiral galaxy, the stars move in a circular motion around the galactic center, and the relation between velocity and the orbital radius is referred to as the rotation curve. Previous astronomical observation data indicate that the rotation curve is flat at the periphery of the galaxy, which completely dissatisfies Keplerian decline. Assuming…

A low-cost solar simulator using a LCD projector as a light source has been developed and tested successfully. The prepared simulator has an illumination spectral at the visible light region and is controllable using a computer. The prepared simulator with controllable spectral filter was used to utilize the current-voltage (I-V) measurement for…

Teaching materials used in distance education are generally obtained from the internet as ready-made by teachers. Materials such as simulation, animation and presentation are usually limited to the frame drawn by the creator and do not allow changes outside this limit. In addition, many of these types of materials do not have a feedback mechanism.…

Understanding simple electric DC circuits often represents a great challenge to many students in lower secondary schools. As a result, students' knowledge of this subject is often dominated by alternative conceptions, even after instruction. One of the reasons for these learning difficulties is the intangibility of key physical quantities and…

3D printing (additive manufacturing) is an emerging technology with the ability to make complex, free-form shapes from materials including plastics, metals and ceramics. While additive manufacturing has many advantages over more traditional processes, it can be difficult to control, which can then lead to defects in the finished part. Closed-loop…

In this work we discuss the intricacies of a simulation using the MS Excel spreadsheet that allows to study in detail the process of heat transfer between two reservoirs at different temperatures through a conducting rod when heat losses are neglected. The proposed physical model computes the time dependence of the reservoir temperatures and…