Instructive, inexpensive, and environmentally friendly laboratory syntheses of two highly luminescent copper(I) complexes CuI(PPh[subcript 3])[subscript 2](py[superscript R]) (py[superscript R] = pyridine, 4-cyanopyridine) are described for second-year/upper-division undergraduate inorganic chemistry students. Both complexes exhibit bright…

Considering the large number of magnetic stirring hot plates that are damaged or unused in chemical laboratories, this Technology Report presents guidelines for students to be able to diagnose problems, and repair and maintain magnetic stirring hot plates using common and low-cost parts, or even repurposed materials. In addition, this paper…

Reported herein is a multidisciplinary laboratory experiment for advanced undergraduate students that includes elements of material synthesis, in the synthesis of cyclodextrin-containing metal-organic frameworks (CD-MOFs), and environmental chemistry, in the use of these MOFs for pollutant removal. This multiday laboratory experiment starts with…

In this organic chemistry laboratory experiment, students are guided through a series of exercises to understand the behavior of compounds during liquid-liquid extraction. Aspects of density, structure, solubility, acid-base theory, and pK[subscript a] are all incorporated into activities that students complete in groups. After using their initial…

This paper presents an experiment in which students determine the mass sensitivity of three crystal quartz resonators, designed to be carried out in "Physics Laboratory II" at the Institute of Experimental Physics, University of Wroclaw. The authors discuss the process of setting up the experiment and the results of the measurements.…

This laboratory exercise investigates the influence of population density on offspring number and size in burying beetles. Students test the theoretical predictions that brood size declines and offspring size increases when competition over resources becomes stronger with increasing population density. Students design the experiment, collect and…

The laboratory (lab) frame angular distribution derived in two-body scattering theory exhibits a singularity at the maximum lab scattering angle. The singularity appears in the kinematic factor that transforms the centre of momentum (cm) angular distribution to the lab angular distribution. We show that it is caused in the transformation by the…

To overcome students' inaccurate prior knowledge on primary additive colours, a coloured-light mixer has been constructed to enable students to observe directly the colours produced and reach the conclusion by themselves that the three primary colours of light are red, green, and blue (NOT red, yellow, and blue). Three closely packed tiny…

In this paper we analyse the behaviour of a small-scale model of a magnetic levitation system based on the Inductrack concept. Drag and lift forces acting on our prototype, moving above a continuous copper track, are studied analytically following a simple low-speed approach. The experimental results are in good agreement with the theoretical…

Single photons are used for fundamental quantum physics experiments as well as for applications. Originally being a topic of advance courses, such experiments are increasingly a subject of undergraduate courses. We provide interactive screen experiments (ISE) for supporting the work in a real laboratory, and for students who do not have access to…

This experiment was developed as a means of incorporating instrumental analyses into an introductory chemistry laboratory. A two-component solid mixture of caffeine and ibuprofen is separated through a series of solution extractions and precipitation and their relative amounts measured. These compounds were chosen because the combination of…

When FT-NMR is used to collect data without a sufficient delay time between subsequent pulses, the integrated area under certain peaks may result in a lower value than should be observed under appropriate conditions. This discrepancy in integration may deceive the inexperienced eye and consequently can lead to a wrong assignment of the NMR…

Waste newspaper is pulped with acid and its cellulose is hydrolyzed. The resulting glucose syrup is fermented with yeast and distilled to give ethanol. The experiment highlights the potential of applied chemistry to confront problems of economic importance, that is, the effective utilization of biomass to reduce dependence on non-renewable…

Treatment of phenylacetic acid with 90% HNO[subscript 3] yields a product, I, whose observed melting point is 175-179 degrees C and whose equivalent weight is approximately 226 grams. Treatment of phenylacetic acid with 70% HNO[subscript 3] yields a product, II, whose observed melting point is 106-111 degrees C and whose equivalent weight is…

The aryl sulfonate ester, menthyl N-acetylsulfanilate, is synthesized from N-acetylsulfanilyl chloride and menthol in pyridine, then pyrolyzed (thermally decomposed) at reduced pressure. The volatile (elimination) products of the reaction are analyzed using gas chromatography, and the resulting product distribution is used to determine whether the…