In this work, we analyze the results obtained by a group of freshmen students in a test of prior knowledge on technical drawing carried out before and after attending an introductory course on this subject. The aim of this course was to help students to gain knowledge necessary to take full advantage of the CAD software that is regularly used to…

Discusses the distinction between drawing and constructing in dynamic geometry environments. (MKR)

Computer Aided Design and Drafting (CADD) programs are used to teach drafting at an Indiana high school. The school system's maintenance department shared use of the software and equipment to produce original drawings of school buildings. (MLF)

Studies whether traditional drafting equipment (TRAD) or computer aided drafting equipment (CAD) is more effective. Proposes that students using only CAD can learn principles of drafting as well as students using only TRAD. Reports no significant difference either on achievement or attitude. (MVL)

Advances four propositions in an effort to provide a frame of reference for a new generation of interactive engineering graphics scholars. Suggests the integration of traditional engineering graphics with new production tools such as computer-aided design drafting. Proposes that graphics problem-solving educational opportunities be maximized. (CW)

Demonstrates one method for finding parallel tangents to a cylinder based on geometric properties of the three dimensional representation of the cylinders. Uses rotational transformations to obtain a three dimensional view. Provides a starting point for those studying geometric methods as a lead into computer assisted drafting. (CW)

Argues for a legitimate role of manually expressed engineering graphics within engineering education as a needed support for computer-assisted drafting work. Discusses what and how students should learn as well as trends in engineering graphics education. Compares and contrasts manual and computer drafting methods. (CW)

Discusses coordinate systems, units of measure, scaling and levels as they relate to a database generated by a computer in a spatial rather than planer location. Describes geometric-oriented input, direct coordinates, transformations, annotation, editing and patterns. Stresses that hand drafting emulation is a short-sighted approach to…