We describe a simple STEM project for students to learn to measure atmospheric pressure by using a sensor of the type BMP180 together with the Arduino electronic platform. The collected experimental data, together with simple experiments, can be used to study the different pressure units and the relationship between pressure and force. Also, they…

Described is an established geophysics project to construct a solar wind monitor based on a nT resolution fluxgate magnetometer. Low-cost and appropriate from school to university level it incorporates elements of astrophysics, geophysics, electronics, programming, computer networking and signal processing. The system monitors the earth's field in…

This paper describes a number of active learning strategies based on implementing the Raspberry Pi as low-cost single-board computing device for carrying out physics laboratory activities. This Microcomputer-Based Laboratory (MBL) Project has been funded by the Baden-Württemberg Foundation and it encompasses the use of high-accuracy yet…

The Timepix hybrid silicon pixel detector has been used to investigate the inverse square law of radiation from a point source as a demonstration of the CERN [at] school detector kit capabilities. The experiment described uses a Timepix detector to detect the gamma rays emitted by an [superscript 241]Am radioactive source at a number of different…

The Mechanical Equivalent of Heat Apparatus from PASCO scientific provides the means for doing a simple experiment to determine the mechanical equivalent of heat, "J." A necessary step of this experiment is to determine the temperature of an aluminum cylinder. By measuring the resistance of a thermistor embedded in the cylinder, one is able to…

Offers some strategies for enabling science teachers to make better use of data-logging methods. These ideas are grounded in the belief that science teachers are expert lesson planners. Benefits gained for students using data-logging techniques are more likely to be secured through teachers re-interpreting their planning approaches in the new…

A software tool called 3D-LAB has been developed for learning and teaching three-dimensional geometry. With this microworld, educators and students can display three dimensional solid objects, rotate them, modify them, open them up, draw points and segments, and measure lengths, areas, volumes, and angles. The major characteristics of this tool…