Parallel analysis has been considered one of the most accurate methods for determining the number of factors in factor analysis. One major advantage of parallel analysis over traditional factor retention methods (e.g., Kaiser's rule) is that it addresses the sampling variability of eigenvalues obtained from the identity matrix, representing the…

The partial correlation coefficient (PCC) is used to quantify the linear relationship between two variables while taking into account/controlling for other variables. Researchers frequently synthesize PCCs in a meta-analysis, but two of the assumptions of the common equal-effect and random-effects meta-analysis model are by definition violated.…

Multilevel structural equation (MSEM) models allow researchers to model latent factor structures at multiple levels simultaneously by decomposing within- and between-group variation. Yet the extent to which the sampling ratio (i.e., proportion of cases sampled from each group) influences the results of MSEM models remains unknown. This paper…

The aim of this study was to compare, by simulation, the accuracy of mapping a cut-score from one test to another by expert judgement (using the Angoff method) versus the accuracy with a small-sample equating method (chained linear equating). As expected, the standard-setting method resulted in more accurate equating when we assumed a higher level…

Meta-analyses are often used to synthesize the findings of studies examining the correlational relationship between two continuous variables. When only dichotomous measurements are available for one of the two variables, the biserial correlation coefficient can be used to estimate the product-moment correlation between the two underlying…

Purpose: This paper aims to identify the relationship between organizational learning culture, psychological contract breach, work engagement, training simulation and transfer of training, to examine the effect of transfer of training on organizational citizenship behaviour and to determine the mediating effect of transfer of training on the…

It is more common for educational and psychological data to be nonnormal than to be approximately normal. This tendency may lead to bias and error in point estimates of the Pearson correlation coefficient. In a series of Monte Carlo simulations, the Pearson correlation was examined under conditions of normal and nonnormal data, and it was compared…

Exploratory factor analysis (EFA) is used routinely in the development and validation of assessment instruments. One of the most significant challenges when one is performing EFA is determining how many factors to retain. Parallel analysis (PA) is an effective stopping rule that compares the eigenvalues of randomly generated data with those for…

An automated item selection procedure in Mokken scale analysis partitions a set of items into one or more Mokken scales, if the data allow. Two algorithms are available that pursue the same goal of selecting Mokken scales of maximum length: Mokken's original automated item selection procedure (AISP) and a genetic algorithm (GA). Minimum…

The increasing use of ordinal variables in different fields has led to the introduction of new statistical methods for their analysis. The performance of these methods needs to be investigated under a number of experimental conditions. Procedures to simulate from ordinal variables are then required. In this article, we deal with simulation from…

The primary purpose of this quantitative study was to examine if simulation training correlated with the decision-making abilities of firefighters from two departments (one in a mountain state and one in a southwest state). The other purposes were to determine if firefighter demographics were correlated with the completion of the simulation…

Estimation problems associated with the correlated-trait correlated-method (CTCM) parameterization of a multitrait-multimethod (MTMM) matrix are widely documented: the model often fails to converge; even when convergence is achieved, one or more of the parameter estimates are outside the admissible parameter space. In this study, the authors…

In multilevel modeling, group-level variables (L2) for assessing contextual effects are frequently generated by aggregating variables from a lower level (L1). A major problem of contextual analyses in the social sciences is that there is no error-free measurement of constructs. In the present article, 2 types of error occurring in multilevel data…

The 3PL model is a flexible and widely used tool in assessment. However, it suffers from limitations due to its need for large sample sizes. This study introduces and evaluates the efficacy of a new sample size augmentation technique called Duplicate, Erase, and Replace (DupER) Augmentation through a simulation study. Data are augmented using…

In multilevel modeling (MLM), group-level (L2) characteristics are often measured by aggregating individual-level (L1) characteristics within each group so as to assess contextual effects (e.g., group-average effects of socioeconomic status, achievement, climate). Most previous applications have used a multilevel manifest covariate (MMC) approach,…