We have introduced a novel approach to competency-based education in mechatronics from the undergraduate to the postgraduate level. What distinguishes this approach is the integration of modeling and control of sampled systems right from the beginning of the undergraduate education. It is achieved by changing the structure of the first-semester…

Contribution: This paper has demonstrated that the use of blended learning in an electrical machines course has increased student engagement, pass rate, and scores across the GPA spectrum. Background: Lack of engagement by students in electric machine courses have been reported across the world. Interventions however, usually take the form of…

This paper presents a series of course modules developed as a high-impact and cost-effective learning tool for modeling and simulating the microfabrication process and design of microelectromechanical systems (MEMS) devices using three-dimensional (3-D) printing. Microfabrication technology is an established fabrication technique for small and…

This paper discusses the planning and development of student training and activities for the Powerline Communications Laboratory at the Technical Education Institute (TEI), Patras, Greece. Powerline communications is currently an active area of research and development that combines three separate specializations from the standard training of…

Ac-powered contactors are extensively used in industry in applications such as automatic electrical devices, motor starters, and heaters. In this work, a practical session that allows students to model and simulate the dynamic behavior of ac-powered electromechanical contactors is presented. Simulation is carried out using a rigorous parametric…

In this paper, a pedagogical software for the design and analysis of loudspeaker systems is presented, with emphasis on training students in the interaction between system parameters. Loudspeakers are complex electromechanical system, whose behavior is neither intuitive nor easy to understand by inexperienced students. Although commercial…

Complex multistep problem exercises are one way to enhance engineering students' learning of electromagnetics (EM). This study investigates whether exposure to complex problem exercises during an introductory EM course improves students' conceptual and procedural knowledge. The performance in complex problem exercises is compared to prior success…

The design of the drive system for an automatic machine and its correct sizing is a very important competence for an electrical or mechatronic engineer. This requires knowledge that crosses the fields of electrical engineering, electronics and mechanics, as well as the skill to choose commercial components based upon their technical documentation.…

If we aim to enhance the interest of students in engineering and therefore produce the best engineers, it is essential to strengthen the pipeline to high school education. This paper discusses several outreach activities undertaken by the Faculty of Engineering and Faculty of Education, University of Ottawa (UO), Ottawa, ON, Canada, to help the…

A microelectro-mechanical systems (MEMS) laboratory course (MEMSlab) in the Mechanical and Process Engineering Department at the Swiss Federal Institute of Technology (ETH Zurich), is presented. The course has been taught for four years and has been attended primarily by Master's students from mechanical and electrical engineering; since fall…

This paper presents a low-cost hands-on experiment for a classical undergraduate controls course for non-electrical engineering majors. The setup consists of a small dc electrical motor attached to one of the ends of a light rod. The motor drives a 2-in propeller and allows the rod to swing. Angular position is measured by a potentiometer attached…

This paper describes the goals, pedagogical system, and educational outcomes of a three-semester curriculum in microelectromechanical systems (MEMS). The sequence takes engineering students with no formal MEMS training and gives them the skills to participate in cutting-edge MEMS research and development. The evolution of the curriculum from…

The Internet provides an opportunity for students to access laboratories from outside the campus. This paper presents a Web-based remote access real-time laboratory using SCADA (supervisory control and data acquisition) control. The control of an induction motor is used as an example to demonstrate the effectiveness of this remote laboratory,…

This paper details a successful and inexpensive implementation of a remote laboratory into a distance control systems course using readily available hardware and software. The physical experiment consists of a beach ball and a dc blower; the control objective is to make the height of the aerodynamically levitated beach ball track a reference…