This research aims to increase our understanding about the effects of active learning, applying problem-based learning (PBL) methodologies to increase student motivation in various graphic engineering classes. The measurement instruments included a cross-sectional survey (n = 269) carried out during the years 2015 to 2019 through triangulation of…

This paper presents a reflective analysis of a novel approach to Problem-Based Learning (PBL) to teach abstract concepts in a large-class setting, specifically tailored for a third-year required undergraduate course, "Introduction to Geotechnical Engineering." The primary objective is to enhance student engagement and learning outcomes…

Can you ask students from three different bachelor programmes to help solve planning and routeing problems for hospitals? In the presented case an interdisciplinary approach was shown to be successful after some redesign. Students from Applied Mathematics, Civil Engineering and Industrial & Engineering Management jointly designed solutions for…

Contribution: This paper reports a curriculum development in hybrid problem-based learning (h-PBL), addresses the design, implementation, effectiveness, and assessment issues of h-PBL, and explains the mixed results observed regarding the impact of problem-based learning (PBL) on student grades from a hybrid perspective. Background: The effect of…

This paper describes a non-classical logic course primarily indicated for graduate students in electrical engineering and energy engineering. The content of this course is based on the vision that it is not enough for a student to indefinitely accumulate knowledge; it is necessary to explore all the occasions to update, deepen, and enrich that…

Increased attention to the need for constructively aligned teaching and learning in interdisciplinary higher education in engineering is observed. By contrast, little research has been conducted on the implementation of the outcome-based pedagogical approach to interdisciplinary higher education in engineering. Therefore, the present design-based…

This paper describes the experiences of using an advanced, low-cost robot in science, technology, engineering, and mathematics (STEM) education. It presents three innovations: It is a powerful, cheap, robust, and small advanced personal robot; it forms the foundation of a problem-based learning curriculum; and it enables a novel multi-robot…

This paper describes a newly designed upper-level undergraduate and graduate course, Autonomous Mobile Robots. The course employs active, cooperative, problem-based learning and is grounded in the fundamental computational problems in mobile robotics defined by Dudek and Jenkin. Students receive a broad survey of robotics through lectures, weekly…

In this paper, a course on applied superconductivity is described. The course structure is outlined and the learning objectives and the learning activities are described. The teaching was multidisciplinary given by four departments each contributing with their expertise. Being applied superconductivity, the focus was on an application, which could…

This paper presents the structure of an undergraduate course entitled "programming techniques and the use of specialised software in structural engineering" which is offered to the fifth (final) year students of the Civil Engineering Department of Aristotle University Thessaloniki in Greece. The aim of this course is to demonstrate the…

This study investigates the relationship between student influence and academic self-efficacy in a sample of 275 students in two Master's programmes in Engineering. Students in only one of the programmes studied according to problem-based learning (PBL). Results indicate that students choosing strategies to influence course content or structure,…

This paper presents a new laboratory-based module for embedded systems teaching, which addresses the current lack of consideration for the link between hardware development, software implementation, course content and student evaluation in a laboratory environment. The course introduces second year undergraduate students to the interface between…

The University of Sydney has offered an undergraduate course in particle technology using a contemporary problem based learning (PBL) methodology since 2005. Student learning is developed through the solution of complex, open-ended problems drawn from modern chemical engineering practice. Two examples are presented; i) zero emission electricity…

In this paper the authors analyse the design and implementation of a course about learning management systems (LMS). The course was first given in Cuba and then in Guatemala and Peru, within the project USo+I: "Universidad, Sociedad e Innovacion, Mejora de la pertinencia de la educacion en las ingenierias de Latinoamerica" financed by…

This article presents the results of two studies on using an innovative pedagogical strategy in teaching mathematical modelling and applications to engineering students. Both studies are dealing with introducing non-traditional contexts for engineering students in teaching/learning of mathematical modelling and applications: environment and…