This article presents the design and development of i*CATch, a construction kit for physical and wearable computing that was designed to be scalable, plug-and-play, and to provide support for iterative and exploratory learning. It consists of a standardized construction interface that can be adapted for a wide range of soft textiles or electronic…

Engaging students in science learning can be challenging, and incorporating new forms of technology into science has been shown to provide creative learning experiences. However most technology enhanced learning and e-Science experiences to date have been designed and run by researchers. There is significant challenge in moving these experiences…

Describes a simple circuit based on an inexpensive quad operational amplifier that permits a direct-reading temperature instrument to be constructed using silicon diodes. Encourages the use of this equipment in introductory thermal experiments. (DDR)

Scientists need to measure and communicate, to handle information, and model ideas. In essence, they need to process information. Young scientists have the same needs. Computers have become a tremendously important addition to the processing of information through database use, graphing and modeling and also in the collection of information…

Describes an experiment that uses the Tain Electronics TCS2 interface to investigate the relationship between force, mass, and acceleration. Discusses the following topics: assembling the system, forces in the system, software, and data analysis. (JRH)

The main part of this project involved using a computer, either an Apple or an IBM, as a chart recorder for the infrared (IR) and nuclear magnetic resonance (NMR) spectrophotometers. The computer "reads" these machines and displays spectra on its monitor. The graphs can then be stored for future reference and manipulation. The program to…

This project involved interfacing of microcomputers with three chemical instruments--Nuclear Magnetic Resonance (NMR), Infrared Spectroscopy (IR), and the spectrophotometer. A Pascal program called "Spectrum" allows data from the NMR to be read and graphed, a specific area of the graph zoomed, ratios of specified areas of the graph…

Describes a simple computer-interface experiment for recording the response of an RC network to an arbitrary input excitation. The setup is used to pose a variety of open-ended investigations in network modeling by varying the initial conditions, input signal waveform, and the circuit topology. (DDR)

The IADIS CELDA 2012 Conference intention was to address the main issues concerned with evolving learning processes and supporting pedagogies and applications in the digital age. There had been advances in both cognitive psychology and computing that have affected the educational arena. The convergence of these two disciplines is increasing at a…