Science and engineering students in the second semester of a calculus-based physics sequence typically study and measure the on-axis magnetic field for a multiple, circular turn coil. There are four benefits to this approach: 1) an analytical solution is easily obtained, 2) the coil is easily constructed using tightly wound, high-gauge wire where…

This paper describes a student-centered approach to teaching and learning physics in a high school classroom. The teacher designs and uses a 5E learning cycle to teach series and parallel electric circuits. This article provides an example of the implementation of 5E model for a physics lesson to address three-dimensional learning-science and…

We report on the study of student difficulties regarding a heat engine in the context of a Stirling cycle by the method of measurement. An in-class test about a Stirling engine with a regenerator was taken by three classes, and the students were asked to perform one of the most basic activities--calculate the efficiency of the heat engine. Our…

The introduction of the Wireless Smart Cart by PASCO scientific in April 2016 has ushered in a paradigm shift in the design and implementation of low-cost undergraduate physics and engineering laboratory experiments. The use of smartphones in experimental physics is by now widely accepted and documented. The smart cart in combination with…

This article describes an experiment that can be done in the classroom in a simple way, with the support of a "homemade" device or as a laboratory practice with the support of PASCO equipment. Through a theory-practice sequence, kinematic and dynamic equations were checked with qualitative and quantitative analysis, emphasizing the…

This research aimed to explore the effects of a virtual lab (VL) and a Microcomputer-based Lab (MBL) on students' performance in scientific modeling. A web-based virtual lab and a low-cost MBL were proposed to help first-year engineering students build scientific models. Empirical research was done in a slope motion experiment. The participants…

This paper describes a simple experiment that lets first-year physics and engineering students discover an important physical property of a Slinky. The restoring force for the fundamental oscillation frequency is provided only by those coils between the support and the Slinky center of mass.

The present study uses the intuitive rules theory as a framework to examine whether some of the difficulties in dealing with errors and uncertainties observed among students in the university physics laboratory can stem from their use of intuitive rules. The study also examines the relationship between the use of intuitive rules and laboratory…

A two-axis solar tracker and its interactive kiosk were designed by an interdisciplinary team of students and faculty. The objective was to develop a publicly accessible kiosk that would facilitate the study of energy usage and production on campus. Tracking is accomplished by an open-loop algorithm, microcontroller, and ham radio rotator. Solar…

The performance of any engineering component depends on and is limited by the properties of the material from which it is fabricated. It is crucial for engineering students to understand these material properties, interpret them and select the right material for the right application. In this paper we present a new method to engage students with…

In this paper we discuss a pedagogical approach aimed at pointing out the role played by the Boltzmann factor in describing phenomena usually perceived as regulated by different mechanisms of functioning. Experimental results regarding some aspects of a chemical reaction and of the viscous flow of some liquids are analysed and described in terms…

In traditional teaching, the fundamental concepts of electromagnetic induction are usually quickly analyzed, spending most of the time solving problems in a more or less rote manner. However, physics education research has shown that the fundamental concepts of the electromagnetic induction theory are barely understood by students. This article…

A simple experiment to reveal the dimension of the pore space in sponges is proposed. This experiment is suitable for the first year of a physics or engineering course. The calculated dimension of the void space in a sponge of density 16 mg cm[superscript -3] was 2.948 [plus or minus] 0.008. (Contains 2 figures.)

A ladder network constructed by an elementary two-terminal network consisting of a parallel resistor-inductor block in series with a parallel resistor-capacitor block sometimes is said to have a non-dispersive dissipative response. This special ladder network is created iteratively by replacing the elementary two-terminal network in place of the…

These proceedings contain the papers of the 18th International Conference on Cognition and Exploratory Learning in the Digital Age (CELDA 2021), held virtually, due to an exceptional situation caused by the COVID-19 pandemic, from October 13-15, 2021, and organized by the International Association for Development of the Information Society…