Contribution: This article presents the design, creation, testing, and results after the use of a 3-D-printed educational tool that helped a blind student learning electric circuits theory in higher education. Background: Educational tools oriented to visually impaired and blind students in higher education are limited or even nonexistent in the…

Contribution: A semester-long project, geared towards a multidisciplinary group of undergraduate engineering students, to design and simulate a large-scale microelectromechanical systems (MEMS) 2-D optical scanner is presented. Background: MEMS component design and fabrication typically requires a cleanroom and costly high-vacuum equipment; these…

Contribution: The NEWTON fabrication laboratory (Fab Lab) Education Initiative assesses the effectiveness of Fab Lab-based learning on K-12 students' attitude toward learning science, technology, engineering, art, and mathematics (STEAM). It considers two aspects: (1) students' motivation and affective state and (2) students' observations and…

This paper presents a series of course modules developed as a high-impact and cost-effective learning tool for modeling and simulating the microfabrication process and design of microelectromechanical systems (MEMS) devices using three-dimensional (3-D) printing. Microfabrication technology is an established fabrication technique for small and…

A lithography lab course has been developed that is applicable to students from the middle-school level up to college students. It can also be inserted into electronics technology or similar courses in two- and four-year colleges, or used to demonstrate applications of polymers in chemistry classes. Some of these techniques would enable research…