In a traditional regression-discontinuity design (RDD), units are assigned to treatment and comparison conditions solely on the basis of a single cutoff score on a continuous assignment variable. The discontinuity in the functional form of the outcome at the cutoff represents the treatment effect, or the average treatment effect at the cutoff.…

In a traditional regression-discontinuity design (RDD), units are assigned to treatment on the basis of a cutoff score and a continuous assignment variable. The treatment effect is measured at a single cutoff location along the assignment variable. This article introduces the multivariate regression-discontinuity design (MRDD), where multiple…

Regression discontinuity design (RD) has been widely used to produce reliable causal estimates. Researchers have validated the accuracy of RD design using within study comparisons (Cook, Shadish & Wong, 2008; Cook & Steiner, 2010; Shadish et al, 2011). Within study comparisons examines the validity of a quasi-experiment by comparing its…

The goal of this paper is to provide guidance for applied education researchers in using multi-level data to study the effects of interventions implemented at the school level. Two primary approaches are currently employed in observational studies of the effect of school-level interventions. One approach employs intact school matching: matching…

In this article, we review past studies comparing randomized experiments to regression discontinuity designs, mostly finding similar results, but with significant exceptions. The latter might be due to potential confounds of study characteristics with assignment method or with failure to estimate the same parameter over methods. In this study, we…

In this paper, the authors examine some of the ways that different types of non-equivalent comparison groups can be used to strengthen causal inferences based on regression discontinuity design (RDD). First, they consider a design that incorporates pre-test data on assignment scores and outcomes that were collected either before the treatment…

The sharp regression discontinuity design (RDD) has three key weaknesses compared to the randomized clinical trial (RCT). It has lower statistical power, it is more dependent on statistical modeling assumptions, and its treatment effect estimates are limited to the narrow subpopulation of cases immediately around the cutoff, which is rarely of…

Some form of a short interrupted time series (ITS) is often used to evaluate state and national programs. An ITS design with a single treatment group assumes that the pretest functional form can be validly estimated and extrapolated into the postintervention period where it provides a valid counterfactual. This assumption is problematic. Ambiguous…

In this article, we note the many ontological, epistemological, and methodological similarities between how Campbell and Rubin conceptualize causation. We then explore 3 differences in their written emphases about individual case matching in observational studies. We contend that (a) Campbell places greater emphasis than Rubin on the special role…

This paper introduces a generalization of the regression-discontinuity design (RDD). Traditionally, RDD is considered in a two-dimensional framework, with a single assignment variable and cutoff. Treatment effects are measured at a single location along the assignment variable. However, this represents a specialized (and straight-forward)…

This study uses within-study comparisons to assess the relative importance of covariate choice, unreliability in the measurement of these covariates, and whether regression or various forms of propensity score analysis are used to analyze the outcome data. Two of the within-study comparisons are of the four-arm type, and many more are of the…