Objectives of a project-oriented mechanical engineering course, Engineering Design, were achieved through a design project, where students designed, built and demonstrated an extreme version of a basic Theo Jansen device. Through this project, junior students in the University of Louisiana fully developed the capability of applying mathematic and…

Technology Engineering is an innovative component of a much larger arena of teaching that effectively uses interactive technology as a method of enhancing learning and the learning environment. Using this method to teach science and math content empowers the teacher and enhances the curriculum as the classroom becomes more efficient and effective.…

Presents an overview of the teaching of plastics at various levels of technological education in the Netherlands focusing on mechanical engineering. Highlights the design process and discusses the Dutch perspective of the role of materials engineering in engineering curricula. (ML)

Presents a rationale for the teaching of materials in engineering degree courses. Reviews the requirements established by various professional engineering bodies in the United Kingdom for accredited engineering degree courses. Discusses the aims of the course as well as instructional concerns. (ML)

The purpose of the Nuclear Power Plant Modules, NPP-1, is to determine the total cost of electricity from a nuclear power plant in terms of all the components contributing to cost. The plan of analysis is in five parts: (1) general formulation of the cost equation; (2) capital cost and fixed charges thereon; (3) operational cost for labor,…

Describes an undergraduate chemical engineering course which has been taught by a self-paced instructional method at Howard University, Washington, D.C. The instructional method, course description, and students' grades are also discussed. (HM)

Describes an undergraduate chemical engineering course which has been offered at the Georgia Institute of Technology. The objectives, structure, instructional materials and content of this course, which emphasizes the structure and usage of computer-aided design systems, are also included. (HM)

Demonstrates one method for finding parallel tangents to a cylinder based on geometric properties of the three dimensional representation of the cylinders. Uses rotational transformations to obtain a three dimensional view. Provides a starting point for those studying geometric methods as a lead into computer assisted drafting. (CW)

Describes a laboratory experiment for freeze-drying fruits and vegetables which aims to expose college students to the principles of drying and simultaneous heat and mass transfer. The experimental apparatus, procedure of the experiment, and data analysis are also included. (HM)

This set of lecture notes is used as a supplemental text for the teaching of fluid dynamics, as one component of a thermodynamics course for engineering technologists. The major text for the course covered basic fluids concepts such as pressure, mass flow, and specific weight. The objective of this document was to present additional fluids…

The nine Reactor Statics Modules are designed to introduce students to the use of numerical methods and digital computers for calculation of neutron flux distributions in space and energy which are needed to calculate criticality, power distribution, and fuel burnup for both slow neutron and fast neutron fission reactors. The last module, RS-9,…

Discusses coordinate systems, units of measure, scaling and levels as they relate to a database generated by a computer in a spatial rather than planer location. Describes geometric-oriented input, direct coordinates, transformations, annotation, editing and patterns. Stresses that hand drafting emulation is a short-sighted approach to…

Suggests a method of integrating teaching microcomputer graphics in engineering curricula without encroaching on the fundamental engineering courses. Includes examples of engineering graphics produced by commercial programs and others produced by high-level language programing in a limited credit hour segment of an educational program. (CW)

Describes the process of planning, designing and implementing a computer-assisted design laboratory to serve both a freshman engineering graphics and a sophomore engineering design course. Discusses some of the impact that this development had on other college facilities. Includes goals, testing, installation, current use, examples of assignments,…

Discusses the similarities, differences, advanced features, applications and number of users of five microcomputer computer-aided design (CAD) packages. Included are: "AutoCAD (V.2.17)"; "CADKEY (V.2.0)"; "CADVANCE (V.1.0)"; "Super MicroCAD"; and "VersaCAD Advanced (V.4.00)." Describes the…