Here, a relatively simple laboratory experiment of a physical pendulum, suitable for students of science and engineering in the first courses of university physics, is presented to illustrate its dynamic behavior and to determine its inertia moment. To this end, a long wooden rod of length L = 99.8 cm and cross-section radius R = 1.73 cm was used…

A 2.7 m long stringless pendulum was set up to measure the coefficient of rolling friction of various balls, at higher rolling speeds than usually observed with a short stringless pendulum. The arrangement is easy to set up and makes an impressive classroom demonstration as well as an interesting laboratory experiment.

The magnetic field of Earth, B[subscript e], is an intriguing topic in the introductory physics curriculum that engages students' curiosity and inspires numerous speculations about the nature of this phenomenon. There are several methods for measuring Earth's magnetic field. Probably, the most widespread and visual method of measuring the field in…

In this study, we derived several formulas for the currents induced in a circular loop by a magnet connected to a spring-based simple harmonic oscillation system. In addition, we conducted an experiment for measuring the induced currents and compared the results with the theoretical prediction. It was confirmed that the prediction from the derived…

The article introduces a low-cost Arduino sensor into the Young's modulus determination laboratory for physics university students. A stainless steel ruler is used as a cantilever beam. Its free end attached a mass is slightly bent and released to make it oscillate as a simple harmonic motion. The Arduino sensor detects the moving mass's frequency…

The pendulum was an important scientific instrument in the 17th century. It became a typical textbook problem in the 18th century. After the introduction of vectors in physics in the 1890s, the pendulum problem started to be progressively solved in the manner we know nowadays from introductory mechanics courses. Starting from "F = ma"…

In general, undergraduate experimental physics laboratories do not usually have experiments designed to address rolling friction and to measure the value of the rolling friction coefficient. This work explores an experiment, which has the potential to arouse students' curiosity about rolling friction by addressing a counterintuitive aspect of the…

The dynamic study of pendulum systems is considered an indispensable subject for physics and mechanics students in colleges and high schools. In this paper, a detailed methodology is given concerning the use of smartphones in pedagogical practical work for studying the dynamics of pendulum systems. Whereas, three aspects have been discussed…

In an article in this journal, it was shown that air resistance could never be a significant source of error in typical free-fall experiments in introductory physics laboratories. Since projectile motion is the two-dimensional version of the free-fall experiment and usually follows the former experiment in such laboratories, it seemed natural to…

We describe an educational activity that can be done by using smartphones to collect data in physics experiments aimed to measure the oscillating period of a spring-mass system and the elastic constant of the helicoidal spring by the dynamic method. Results for the oscillating period and for the elastic constant of the spring agree very well with…

We report the findings of an empirical study that investigated whether the source of data--firsthand or secondhand data gained from lab work experiments--has an influence on students' learning outcomes. Results indicate that students' choice of a correct or incorrect hypothesis for a pendulum lab experiment on the influence of the mass of the bob…

A novel method of measuring the coefficients of kinetic and rolling friction is proposed. The method is simple to implement and reliable. Samples of measurements and calculations are presented.

Smartphone-based experimental exercises were incorporated as part of the homework problems in an introductory mechanics course at a university. A quasi-experimental field study with two cohorts design was performed to measure the impact of such exercises on motivation, interest and conceptual understanding. The empirical results on learning…

In the field of physics teaching, the simple pendulum provides a very simple way to study the harmonic oscillator, the source of some fundamental concepts such as periodicity, relaxation time and anharmonicity. As such, its experimental study is frequently integrated into high school or first year university programs. With this in mind, in this…

The cannon boring experiment of Count Rumford, where eight kilograms of water were boiled by metal on metal friction, is investigated. Consideration of this dramatic demonstration can enrich classroom discussions of calorimetry, units of measure, elements, and thermodynamics. A section pertaining to use of the article in the classroom appears…