The partial correlation coefficient (PCC) is used to quantify the linear relationship between two variables while taking into account/controlling for other variables. Researchers frequently synthesize PCCs in a meta-analysis, but two of the assumptions of the common equal-effect and random-effects meta-analysis model are by definition violated.…

Two families of analysis methods can be used for differential item functioning (DIF) analysis. One family is DIF analysis based on observed scores, such as the Mantel-Haenszel (MH) and the standardized proportion-correct metric for DIF procedures; the other is analysis based on latent ability, in which the statistic is a measure of departure from…

Ragin's Qualitative Comparative Analysis (QCA) is often used with small to medium samples where the researcher has good case knowledge. Employing it to analyse large survey datasets, without in-depth case knowledge, raises new challenges. We present ways of addressing these challenges. We first report a single QCA result from a configurational…

Randomized experiments are commonly used to evaluate the effectiveness of educational interventions. The goal of the present investigation is to develop small-sample corrections for multiple contrast hypothesis tests (i.e., F-tests) such as the omnibus test of meta-regression fit or a test for equality of three or more levels of a categorical…

Compressed sensing (CS) is an emerging signal acquisition framework that goes against the traditional Nyquist sampling paradigm. CS demonstrates that a sparse, or compressible, signal can be acquired using a low rate acquisition process. Since noise is always present in practical data acquisition systems, sensing and reconstruction methods are…

Developed a sample-based nonanalytical degrees-of-freedom correction factor for situations sampling both subjects and conditions with measurement data departing from essentially parallel form. Assessed the application of this correction factor through a simulation study involving data sets with a range of design characteristics and manifesting…

Large scale surveys usually employ a complex sampling design and as a consequence, no standard methods for estimation of the standard errors associated with the estimates of population means are available. Resampling methods, such as jackknife or bootstrap, are often used, with reference to their properties of robustness and reduction of bias. A…

This paper describes an item response theory (IRT) based method of differential item functioning (DIF) detection that involves neither separate calibration nor ability grouping. IRT is used to generate residual scores, scores free of the effects of person or group ability and item difficulty. Analysis of variance is then used to test the group…