Item response theory parameters have to be estimated, and because of the estimation process, they do have uncertainty in them. In most large-scale testing programs, the parameters are stored in item banks, and automated test assembly algorithms are applied to assemble operational test forms. These algorithms treat item parameters as fixed values,…

Automated test assembly uses the methodology of mixed integer programming to select an optimal set of items from an item bank. Automated test-form generation uses the same methodology to optimally order the items and format the test form. From an optimization point of view, production of fully formatted test forms directly from the item pool using…

This study examined the performance of the maximum Fisher's information, the maximum posterior weighted information, and the minimum expected posterior variance methods for selecting items in a computerized adaptive testing system when the items were grouped in testlets. A simulation study compared the efficiency of ability estimation among the…

In a typical study comparing the relative efficiency of two item selection rules in computerized adaptive testing, the common result is that they simultaneously differ in accuracy and security, making it difficult to reach a conclusion on which is the more appropriate rule. This study proposes a strategy to conduct a global comparison of two or…

Assessing individual change is an important topic in both psychological and educational measurement. An adaptive measurement of change (AMC) method had previously been shown to exhibit greater efficiency in detecting change than conventional nonadaptive methods. However, little work had been done to compare different procedures within the AMC…

In many practical testing situations, alternate test forms from the same testing program are not strictly parallel to each other and instead the test forms exhibit small psychometric differences. This article investigates the potential practical impact that these small psychometric differences can have on expected classification accuracy. Ten…

The early stage of computerized adaptive testing (CAT) refers to the phase of the trait estimation during the administration of only a few items. This phase can be characterized by bias and instability of estimation. In this study, an item selection criterion is introduced in an attempt to lessen this instability: the D-optimality criterion. A…

This article presents an application of Monte Carlo methods for developing and assembling multistage adaptive tests (MSTs). A major advantage of the Monte Carlo assembly over other approaches (e.g., integer programming or enumerative heuristics) is that it provides a uniform sampling from all MSTs (or MST paths) available from a given item pool.…

Figural matrix items are a popular task type for assessing general intelligence (Spearman's g). Items of this kind can be constructed rationally, allowing the implementation of computerized generation algorithms. In this study, the influence of different task parameters on the degree of difficulty in matrix items was investigated. A sample of N =…

Discusses problems of diagnosing and repairing infeasible linear-programming models in computerized test assembly. Demonstrates that it is possible to localize the causes of infeasibility, although this is not always easy. (SLD)

Reviews optimal test-assembly literature and introduces the contributions to this special issue. Discusses four approaches to computerized test assembly: (1) heuristic-based test assembly; (2) 0-1 linear programming; (3) network-flow programming; and (4) an optimal design approach. Contains a bibliography of 90 sources on test assembly.…

Applied optimal design methods to the item-bank design of adaptive testing for continuous testing situations using a version of the weighted-deviations model (M. Stocking and L. Swanson, 1993) in a simulation. Independent and overlapping item banks used items more efficiently than did a large item bank. (SLD)

New theory and practice in testing is replacing the standard test by the test item bank and classical test theory by item response theory. Eight papers and a commentary are presented in this special issue concerning test item banking. (SLD)

Focuses on the potential contributions of optimal test-design models to practical test-assembly issues that result from limitations in the models or the technology required for their implementation and limitations inherent in the test-assembly process. Outlines research needed to make implementation of these techniques routine in test assembly.…

Compared five item selection rules with respect to the efficiency and precision of trait (theta) estimation at the early stages of computerized adaptive testing (CAT). The Fisher interval information, Fisher information with a posterior distribution, Kullback-Leibler information, and Kullback-Leibler information with a posterior distribution…