Describes equipment and procedures for an experiment using diodes to introduce non-linear electronic devices in a freshman physics laboratory. The experiment involves calculation and plotting of the characteristic-curve and load-line to predict the operating point and compare prediction to experimentally determined values. Background information…

Reports that although excitation at 337nm is less than optimal, detection limits in the range 1-100pg/ml were found. Provides a calibration curve and results for seven organic compounds. (MVL)

Describes a procedure used to optimize instrument performance as taught in a fourth-year undergraduate instrumental analysis course. Gives rules for fixed and variable size simplex and discusses calculations. Also explains use of computer simulation of instruments as a tool in teaching the simplex technique. (JM)

An inexpensive apparatus for demonstrating low temperature mineral synthesis in an undergraduate geology laboratory is described. (Author/SA)

Describes a simple high-performance liquid chromatography experiment for undergraduate biochemistry laboratories. The experiment illustrates the separation of polypeptides by a step gradient elution using a single pump instrument with no gradient attachments. Discusses instrumentation, analysis, a sample preparation, and results. (CW)

Advocates use of Waters Associates Radial Compression Separation System for high performance liquid chromatography. Discusses instrumentation and reagents, outlining procedure for analyzing various foods and discussing typical student data. Points out potential problems due to impurities and pump seal life. Suggests use of ribose as internal…

Described is a multidisciplinary group project for undergraduate students in astronomy and physics. The students design and build a simple radiotelescope subject to a number of realistic constraints such as fixed cost, use of a standard communications receiver, and buying of supplementary building materials off the shelf. (BT)

Presents relevant statistics accumulated in a fall organic laboratory course. Discusses laboratory equipment setup to lower the amount of waste. Notes decreased solid wastes were produced compared to the previous semester. (MVL)

Described is a reliable and predictable laboratory experiment which represents the result of an integrated approach to design with an emphasis on teaching. Notes the flat-celled rig has logged over 100 hours service in 2 years without any problems. (MVL)

Presented is a photoelectric colorimeter which can be assembled by the student. Reports that it can do many of the same analyses as the SPEC 20 but at a greatly reduced cost using older technology. Presents several experiments to use with the colorimeter. (MVL)