Describes the Clinton (MA) secondary school program in plastics technology, which involves (1) mostly 10th graders in a combination classroom-hands-on-activities laboratory program, and (2) 11th and 12th graders in laboratory research/ shadowing/job performance program. Also describes actual laboratory projects, program graduate job placement, and…

Describes apparatus needed and instructions for conducting four experiments. Experiments focus on light waves, measurement of contact resistance, demonstration of longitudinal waves, and a simple method of measuring the refractive indices of transparent plates and liquids. (JM)

Discusses indoor air pollution in general and formaldehyde in particular, citing major sources of formaldehyde in home building materials and home furnishings. Also describes a laboratory procedure necessary to test for formaldehyde levels in the air and in materials. Includes list of equipment required. (JM)

Discusses responsibilities for providing safe experiments and for teaching about safety. Provides lists of references on chemical safety and regulated/potential carcinogens. Also discusses general laboratory safety procedures including waste disposal and recycling of solvents. (JM)

An international project for improvement of an Indonesian university's chemical engineering curriculum and later extended to other institutions and departments, included these changes: greater emphasis on discussion and problem-solving techniques, use of learning modules, introduction of criterion-referenced grading, and extended and improved…

Presents procedures, experiments, demonstrations, teaching suggestions, and information on a variety of chemistry topics including, for example, inert gases, light-induced reactions, calculators, identification of substituted acetophenones, the elements, analysis of copper minerals, extraction of metallic strontium, equilibrium, halogens, and…

Outlines a variety of laboratory procedures, demonstrations, and classroom materials including a three dimensional, moveable cardboard model of the rib cage and diaphragm; a polyphenal oxidase experiment; ringing experiment using Impatiens; enzyme rummy game; and leaf impressions. (DS)

Describes an experimental setup which allows the student to investigate the resonance characteristics of a vibrating plate using a small, circular steel plate clamped around its perpiphery. (HM)

Discusses procedures, theoretical considerations, and results of an experiment involving the preparation of a tetrahedral nickel(II) complex and its transformation into an octahedral species. Suggests that fundamental aspects of coordination chemistry can be demonstrated by simple experiments performed in introductory level courses. (Author/JN)

Describes a student kinetic experiment involving second order kinetics as well as displaying photochromism using a wide variety of techniques from both physical and organic chemistry. Describes measurement of (1) the rate of the recombination reaction; (2) the extinction coefficient; and (3) the ESR spectrometer signal. (Author/JN)

Described are laboratory methods for enumerating microorganisms in food. These methods are utilized to determine if foods are potentially hazardous to the consumer due to high concentrations of microorganisms. Discussed are indicator organisms, including coliforms, interococci, yeasts, and molds; food poisoning organisms (staphylococci and…

Described are experiments used in the "Physical Science and Man" course at Hartley CAE which enable determinations of efficiencies of two energy conversion processes, namely, electricity into heat and burning gas to produce heat. Activities for comparing the processes are suggested. (DS)

Describes a lecture demonstration illustrating Charles's Law with a balloon-balance thermometer. The technique allows a determination of the absolute minimum temperature to within an accuracy of 10 percent of the exact value: -273.15 degrees Celsius. (BT)

A description is given of a chemically-oriented curriculum on "Smoking and Cigarette Smoke" for science and nonscience oriented high school students. Laboratory activity is emphasized. (SA)

Several potential safety problems are identified relative to science teaching: the use of bottled gas or alcohol lamps as heat sources, the hazards of Millon's Reagent for testing for proteins, and the use of silicon tetrachloride to demonstrate properties of chlorides. Science teachers are also warned about potentially dangerous procedures…